JIANG Zhen-ou, LU Guo-shou, GAO Wei, et al. Moulding Process of Total Flavonoids Capsule from Lithocarpus litseifolius[J]. Chinese journal of experimental traditional medical formulae, 2011, 17(15): 52-54.
JIANG Zhen-ou, LU Guo-shou, GAO Wei, et al. Moulding Process of Total Flavonoids Capsule from Lithocarpus litseifolius[J]. Chinese journal of experimental traditional medical formulae, 2011, 17(15): 52-54. DOI: 10.13422/j.cnki.syfjx.2011.15.027.
Moulding Process of Total Flavonoids Capsule from Lithocarpus litseifolius
摘要
目的:探讨木姜叶柯总黄酮胶囊的成型工艺。方法:以休止角、吸湿率、临界相对湿度、堆密度为考察指标
筛选木姜叶柯总黄酮胶囊的成型工艺条件。结果:以微粉硅胶为辅料
用量为10%
临界相对湿度66%
选用0号胶囊
可满足木姜叶柯总黄酮胶囊剂装填要求。结论:该成型工艺合理可行。
Abstract
Objective:To investigate moulding process of total flavonoids capsule from Lithocarpus litseifolius.Method:The moulding process of total flavonoids capsule from L.Litseifolius was selected with angle of repose
moisture absorption rate
critical relative humidity(CRH)
and bulk densityas indexes.Result:The optimum process was as follows:silica gel as excipient and its dosage was 10%
0# vacant capsule was used
CRH was 66%.These conditions could meet the requirements of capsules filled.Conclusion:The moulding process is rational and practicable.
Optimization of Molding Process of Tangshenning Granules with Central Composite Design-response Surface Methodology
Optimization of Discrete Element Simulation Parameter Calibration Method for Traditional Chinese Medicine Extract Powder Under Low Shear Conditions
Related Author
LU Guo-shou
GAO Wei
DENG Yu-yin
JIANG Zhen-ou
FANG Yuan
FAN Zhen-qun
ZHANG Chong
MU Hong
Related Institution
Beijing Key Laboratory for Production Process Control and Quality Evaluation of Chinese Medicine,Beijing University of Chinese Medicine
State Key Laboratory on Technologies for Chinese Medicine Pharmaceutical Process Control and Intelligent Manufacture,Nanjing University of Chinese Medicine